Guys,
Ive got a NV here thats built to the point of setting endplay on the mainshaft. I have not done one of these in a few years, but I seem to remember that there is a special bearing race for the mainshaft, that makes it so the race extends fully into the case. Am I correct? As of right now the race would need ~.320 of shim to set endplay. Either I have the wrong bearing, or the wrong race. When I pulled the trans apart the last builder stacked shims for a total of .320, but I'm not about to put it back in like that.
I'll give zumbrota a call tomorrow, but I figured I'd get a head start by asking here.
Thanks
Ive got a NV here thats built to the point of setting endplay on the mainshaft. I have not done one of these in a few years, but I seem to remember that there is a special bearing race for the mainshaft, that makes it so the race extends fully into the case. Am I correct? As of right now the race would need ~.320 of shim to set endplay. Either I have the wrong bearing, or the wrong race. When I pulled the trans apart the last builder stacked shims for a total of .320, but I'm not about to put it back in like that.
I'll give zumbrota a call tomorrow, but I figured I'd get a head start by asking here.
Thanks
0 commentaires:
Enregistrer un commentaire