47RE is out of my 1997 truck. I'm swapping to a manual so it's up for sale.
Trans has:
Suncoast 44 series Triple Disc converter - DPC went through and restalled in September - it's about 1800rpm. Stockish RPM stall with better fluid coupling.
Garmon Valve body - it actually shifts correctly if you leave it in drive, towing or not. Locks in 2nd, 3rd, and 4th. Cleaned and checked by Garmon while trans was out in September.
Goerend Soft Parts - Just replaced last September
Billet Accumulator, achor, strut, lever and servo
Sonnax Billet One piece input shaft
Mag Hytech Deep pan
Laminated Flexplate
New Mopar sensors on the valvebody in September.
Build was done by a Goerend vendor about a year ago.
Price: $3500 with laminated flexplate, $3750 with the BD SFI rated flexplate and I can deliver within reason in or around Ohio. I will palletize and ship it, but the buyer must cover freight.
For a little more I can include a B&M Trans Super Cooler and 400psi trans lines. Since I'm doing a swap the pedals and steering column could be available as well. I also have a brand new BD Flexplate I was going to install when I was thinking about keeping it auto. It's brand new in the box and can replace the Laminated flexplate for the price above. May even part with ISSPRO EV1 trans temp gauge and sender.
This is a good opportunity to buy a transmission that costs up to or above $5000 most other places. No cores necessary!
Trans has:
Suncoast 44 series Triple Disc converter - DPC went through and restalled in September - it's about 1800rpm. Stockish RPM stall with better fluid coupling.
Garmon Valve body - it actually shifts correctly if you leave it in drive, towing or not. Locks in 2nd, 3rd, and 4th. Cleaned and checked by Garmon while trans was out in September.
Goerend Soft Parts - Just replaced last September
Billet Accumulator, achor, strut, lever and servo
Sonnax Billet One piece input shaft
Mag Hytech Deep pan
Laminated Flexplate
New Mopar sensors on the valvebody in September.
Build was done by a Goerend vendor about a year ago.
Price: $3500 with laminated flexplate, $3750 with the BD SFI rated flexplate and I can deliver within reason in or around Ohio. I will palletize and ship it, but the buyer must cover freight.
For a little more I can include a B&M Trans Super Cooler and 400psi trans lines. Since I'm doing a swap the pedals and steering column could be available as well. I also have a brand new BD Flexplate I was going to install when I was thinking about keeping it auto. It's brand new in the box and can replace the Laminated flexplate for the price above. May even part with ISSPRO EV1 trans temp gauge and sender.
This is a good opportunity to buy a transmission that costs up to or above $5000 most other places. No cores necessary!
0 commentaires:
Enregistrer un commentaire