Have a Precision PT-98 Thumper that has been clipped to 91mm at the cover. G-Trim Turbine 1.00 T6 undivided housing. Journal bearing with normal play ready to run.
Compressor cover has standard 7" radius inlet and 4" slip-on discharge. Tubine housing is 5" v-band exit. Cast compressor wheel. It will move a LOT of air!
Compressor cover was semi-polished by previous owner. If the buyer desires I should be able to have the cover machined for a filter and smoothed for welding or threading on a v-band discharge. I will have to confirm this with my machinist but it shouldn't be a problem.
I never used the turbo as plans changed, came off a mustang that used it for fab only and had been rebuilt beforehand.
These turbos are $2300 from Precision in bone stock form. I'll sell for $1500 shipped anywhere in the lower 48 or I can bring it in person to TS.
REASONABLE offers will be considered.
Compressor cover has standard 7" radius inlet and 4" slip-on discharge. Tubine housing is 5" v-band exit. Cast compressor wheel. It will move a LOT of air!
Compressor cover was semi-polished by previous owner. If the buyer desires I should be able to have the cover machined for a filter and smoothed for welding or threading on a v-band discharge. I will have to confirm this with my machinist but it shouldn't be a problem.
I never used the turbo as plans changed, came off a mustang that used it for fab only and had been rebuilt beforehand.
These turbos are $2300 from Precision in bone stock form. I'll sell for $1500 shipped anywhere in the lower 48 or I can bring it in person to TS.
REASONABLE offers will be considered.
0 commentaires:
Enregistrer un commentaire