I'm sure this has been answered a time or 2 but I haven't found the answered to my questions.
I'll start with the problem. I'm spraying my truck, A LOT, and after about a year of lots of spray it finally popped the head gasket one hot summer night (the bottle pressure was finally high enough I matter). Now I'm in the market for a external wastegate to bleed off my drive pressure/boost to about 50-60psi. This will be welded on to a stock ported 12v manifold.
Now my questions:
What gate is everyone using?
What is everyone doing to keep 50-60psi? Manual controller?
What's the best spot to weld it on the manifold? Middle over the divider? Front half? Or back half?
Thanks in advance for the help.*nx*
I'll start with the problem. I'm spraying my truck, A LOT, and after about a year of lots of spray it finally popped the head gasket one hot summer night (the bottle pressure was finally high enough I matter). Now I'm in the market for a external wastegate to bleed off my drive pressure/boost to about 50-60psi. This will be welded on to a stock ported 12v manifold.
Now my questions:
What gate is everyone using?
What is everyone doing to keep 50-60psi? Manual controller?
What's the best spot to weld it on the manifold? Middle over the divider? Front half? Or back half?
Thanks in advance for the help.*nx*
0 commentaires:
Enregistrer un commentaire