2001 chevy duramax fully built 2.6 truck. No shortcuts taken. 2014 Battle of the Bluegrass points champion.
Engine:
bored .040 over
Carrilo rods
Mahle pistons with reliefs
Socal 6460 Cam
Socal stage 2 heads
Arp main and headstuds
Air:
Haisley HX 60 PPL legal with guillotine
Custom T6 pedestal to keep the charger in the valley
Chiseled A/W equivalent to the precision 2000
All 4in piping to the intake runners
Fuel:
Fleece Dual pumps
Airdog 200
175% exergy injectors
fuel cell in the bed
Trans:
Built Allison with suncoast parts (never had a single problem in 6 years)
3500 stall converter
torque converter lockup switch
Driveline:
DHD 38 spline axles and spool
custom braced housing
Billet adjuster nuts
custom driveshaft with 1480 u-joints
Fleece Big shaft up front
e-locker
4.56 gear
2- 35 x 12.50 sts's up front
4- 35 x 12.50 general grabbers in the back on 17x8 custom rims
Miscellaneous:
Fleece data logger. Logs intake air before and after a/w, intercooler water before and after, boost, drive pressure, egt's on each manifold, and ground speed
Interior gutted but will go with truck if wanted.
All safety features (kill switch, u- joint shields, drive shaft loop, trans blanket, etc.)
Custom built weight box with ice box and 2 batteries mounted
Frame is partially boxed
I'm probably forgetting some important things, just ask.
Asking $50,000 the way it sits. Open to offers.
The truck will have a fresh motor and dyno sheets to with it.
812-599-three1six2
Engine:
bored .040 over
Carrilo rods
Mahle pistons with reliefs
Socal 6460 Cam
Socal stage 2 heads
Arp main and headstuds
Air:
Haisley HX 60 PPL legal with guillotine
Custom T6 pedestal to keep the charger in the valley
Chiseled A/W equivalent to the precision 2000
All 4in piping to the intake runners
Fuel:
Fleece Dual pumps
Airdog 200
175% exergy injectors
fuel cell in the bed
Trans:
Built Allison with suncoast parts (never had a single problem in 6 years)
3500 stall converter
torque converter lockup switch
Driveline:
DHD 38 spline axles and spool
custom braced housing
Billet adjuster nuts
custom driveshaft with 1480 u-joints
Fleece Big shaft up front
e-locker
4.56 gear
2- 35 x 12.50 sts's up front
4- 35 x 12.50 general grabbers in the back on 17x8 custom rims
Miscellaneous:
Fleece data logger. Logs intake air before and after a/w, intercooler water before and after, boost, drive pressure, egt's on each manifold, and ground speed
Interior gutted but will go with truck if wanted.
All safety features (kill switch, u- joint shields, drive shaft loop, trans blanket, etc.)
Custom built weight box with ice box and 2 batteries mounted
Frame is partially boxed
I'm probably forgetting some important things, just ask.
Asking $50,000 the way it sits. Open to offers.
The truck will have a fresh motor and dyno sheets to with it.
812-599-three1six2
0 commentaires:
Enregistrer un commentaire