I am selling the engine out of the race truck. My son has a new job and can't get days off or able to travel for the next 5 years. So I have no need for this to just sit here.
The motor has one pass on it and 3 engine dyno pulls. This is a standard 5.9 bore filled block. The block was new when the motor was built. It has a roller cam, R&R rods, Aries pistons, hardened wrist pins, hamilton head, Harlin and Sharp roller rockers inconel valves, ported and polished both sides and a runner intake, 13mm pump, custom injectors, gear driven fuel and water injection. All steel braded lines, fittings, hoses, brackets and corsa data logger system, boost controller and turbos go with the engine. Most everything came from Schied, It was dynoed at Schied and numbers will be shared with serious buyers. There was no expense spared on the build.
I will also be selling the clutch, bell housing, B&J air shifted 4 speed trans and a billet SCS gear driven transfer case. Nothing will be sold until engine is sold.
There is a lot of money tied up in the engine and it costs a lot to build it. So if you don't have anything good to say or can't afford it, please don't bad mouth it. The only thing I will take on a partial trade is a CR roughly a 1000hp. All parts will have to be proven. 60k 317-710-2236 Call or text. Thanks, Tim
[/URL]
[/URL]
[/URL]
[/URL]
[/URL]
The motor has one pass on it and 3 engine dyno pulls. This is a standard 5.9 bore filled block. The block was new when the motor was built. It has a roller cam, R&R rods, Aries pistons, hardened wrist pins, hamilton head, Harlin and Sharp roller rockers inconel valves, ported and polished both sides and a runner intake, 13mm pump, custom injectors, gear driven fuel and water injection. All steel braded lines, fittings, hoses, brackets and corsa data logger system, boost controller and turbos go with the engine. Most everything came from Schied, It was dynoed at Schied and numbers will be shared with serious buyers. There was no expense spared on the build.
I will also be selling the clutch, bell housing, B&J air shifted 4 speed trans and a billet SCS gear driven transfer case. Nothing will be sold until engine is sold.
There is a lot of money tied up in the engine and it costs a lot to build it. So if you don't have anything good to say or can't afford it, please don't bad mouth it. The only thing I will take on a partial trade is a CR roughly a 1000hp. All parts will have to be proven. 60k 317-710-2236 Call or text. Thanks, Tim
0 commentaires:
Enregistrer un commentaire