Anyone done a hone or bore on a block, compared to a similar setup but with a torque plate on the block for the hone or bore operation.. and have a comparison for compression, blowby or lack of wear on certain areas of the cyinders that might indicate theres enough distortion to lose some compression?
trying to make sense of an otherwise healthy motor thats showing a fair bit of blowby without a lot of abuse.
Dunno if distortion is an issue with 12mm studs as well as 14mm or not? running the unobtanium 625s on there since I had plans for more air and fuel in the future.
trying to make sense of an otherwise healthy motor thats showing a fair bit of blowby without a lot of abuse.
Dunno if distortion is an issue with 12mm studs as well as 14mm or not? running the unobtanium 625s on there since I had plans for more air and fuel in the future.
0 commentaires:
Enregistrer un commentaire